Filter
Top Products
68 Update with your book title
•
Loss of Signal
— Indicates if a signal loss occurred in the cable.
•
Data Ready
— The transceiver has achieved power up and data is ready.
Displaying Optical Transceiver Diagnostics Test Results Table
1
Open the
Optical Transceiver Diagnostics
page.
2
Click
Show All
.
The test is run and the Virtual Cable Test Results Table opens with the following columns:
•
Temp
— Internally measured transceiver temperature.
•
Voltage
— Internally measured supply voltage.
•
Current
— Measured TX bias current.
•
Output Power
— Measured TX output power in milliwatts.
•
Input Power
— Measured RX received power in milliwatts.
•
TX Fault
— Transmitter fault.
Finisair transceivers do not support the transmitter fault diagnostic testing.
•
LOS
— Loss of signal.
•
Data Ready
— The transceiver has archived power up and data is ready.
•
N/A
— Not Available, N/S - Not Supported, W - Warning, E - Error.
Fiber Optic analysis feature works only on SFPs that support the digital diagnostic standard SFF-4872.