Filter
Top Products
88 Adding Parts
www.jp.dell.com | support.jp.dell.com
Adding or Replacing a Video Card
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 9.
CAUTION: To guard against electrical shock, always unplug your
computer from the electrical outlet before opening the cover.
NOTICE: You must use low-profile cards for your computer. A full-size card
can cause damage to the computer or the card.
1
Shut down the computer (see page 34).
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
2
Turn off any attached devices and disconnect them from their
electrical outlets.
3 Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
4 Remove the computer stand (see page 21).
5 Open the computer cover (see page 80).
Removing a Video Card
1 Remove the filler bracket by raising the hinged lever and sliding the
filler bracket up.
2 Press the card lever toward the PCI connector.
3 Pull the card up and out of the card clip.
filler bracket
hinged lever