Filter
Top Products
38 Setting Up Your Computer
www.dell.com | support.dell.com
Setting Up a Printer
CAUTION: Before performing these procedures, read the safety instructions on
page 11.
NOTICE: Complete the operating system setup before you connect a printer to the computer.
See the documentation that came with the printer for setup information, including how to:
• Obtain and install updated drivers.
• Connect the printer to the computer.
• Load paper and install the toner or ink cartridge.
• Contact the printer manufacturer for technical assistance.
Printer Cable
Your printer connects to your computer with either a USB cable or a parallel cable. Your
printer may not come with a printer cable, so if you purchase a cable separately, ensure that
it is compatible with your printer. If you purchased a printer cable at the same time you
purchased your computer, the cable may arrive in the computer box.
Connecting a Parallel Printer
1 Complete the operating system setup, if you have not already done so.
2 Shut down the computer (see "Turning Off Your Computer" on page 42).
NOTICE: For best results, use a 3-m (10-ft) or shorter parallel cable.
3 Attach the parallel printer cable to the parallel connector on the computer and tighten
the two screws. Attach the cable to the connector on the printer and snap the two clips
into the two notches.
3Y647bk0.book Page 38 Wednesday, April 2, 2003 3:24 PM