Filter
Top Products
Dell Converged Enhanced Ethernet Administrator’s Guide 85
53-1002116-01
LLDP configuration and management
8
2. Apply an LLDP profile to the interface.
The following example applies the LLDP profile “network_standard” to the current interface.
switch(conf-if-te-0/10)#lldp profile network_standard
3. Configure the FCoE priority bits for an interface. The value is specified as 0x0-0xff.
switch(conf-if-te-0/10)#fcoe-priority-bits 0x0-0xff
4. Configure the DCBX version for an interface for CEE. For detailed information on these version
command keywords, see “DCBX interaction with other vendor devices” on page 79. The default
is to automatically detect the DCBX version.
switch(conf-if-te-0/10)#lldp version cee
5. Enter the copy command to save the running-config file to the startup-config file.
switch(conf-if-te-0/10)#exit
switch(config)#end
switch#copy running-config startup-config
Clearing LLDP-related information
To clear LLDP-related information, perform the following steps from Privileged EXEC mode.
1. Use the clear command to:
• Clear LLDP neighbor information.
switch#clear lldp neighbors intengigabitethernet 0/1
• Clear LLDP statistics.
switch#clear lldp statistics intengigabitethernet 0/1
Displaying LLDP-related information
To display LLDP-related information, perform the following steps from Privileged EXEC mode.
1. Use the show lldp neighbors command to:
• Display LLDP general information.
switch#show lldp
• Display LLDP interface-related information.
switch#show lldp interface intengigabitethernet 0/1
• Display LLDP neighbor-related information.
switch#show lldp neighbors interface intengigabitethernet 0/1 detail