Filter
Top Products
16 Dell Converged Enhanced Ethernet Administrator’s Guide
53-1002116-01
CEE Command Line Interface
2
NOTE
At system startup, if you try to enter Privileged EXEC mode before the system has fully booted, the
following message is displayed:
%Info: Please wait. System configuration is being loaded.
After the system has fully booted, a RASLOG message indicates that the CEE CLI is ready to accept
configuration commands.
TABLE 3 CEE CLI command modes
Command
mode
Prompt How to access the command mode Description
EXEC switch> Enter the cmsh command at the
Fabric OS prompt after you have
logged in as an appropriate user.
Display running system
information and set
terminal line
parameters.
Privileged
EXEC
switch# From the EXEC mode, enter the
enable command.
Display and change
system parameters.
Note that this is the
administrative mode
and also includes EXEC
mode commands.
Global
configuration
switch(config)# From the EXEC mode, enter the
configure terminal EXEC command.
Configure features that
affect the entire switch.
Interface
configuration
Port-channel:
switch(conf-if-po-63)#
10-Gigabit Ethernet (CEE port):
switch(conf-if-te-0/1)#
VLAN:
switch(conf-if-vl-1)#
From the global configuration mode,
specify an interface by entering one
of the following interface types:
• interface port-channel
• interface intengigabitethernet
• interface vlan
Access and configure
individual interfaces.
Protocol
configuration
LLDP:
switch(conf-lldp)#
Spanning-tree:
switch(conf-mstp)#
switch(conf-rstp)#
switch(conf-stp)#
From the global configuration mode,
specify a protocol by entering one of
the following protocol types:
• protocol lldp
• protocol spanning-tree mstp
• protocol spanning-tree rstp
• protocol spanning-tree stp
Access and configure
protocols.