Filter
Top Products
Troubleshooting Your System | 141
4 Turn off the system and attached peripherals, and disconnect the
system from the electrical outlet.
5 Remove the system-board assembly. See "Removing a System-Board
Assembly" on page 68.
6 Reseat the memory modules in their sockets. See "Installing the
Memory Modules" on page 85.
7 Install the system-board assembly. See "Installing a System-Board
Assembly
" on page 69.
8 Reconnect the system to its electrical outlet, and turn on the system
and attached peripherals.
9 Enter the System Setup program and check the system memory
settings. See "
System Memory" on page 34.
If the problem is not resolved, proceed with the next step.
10 Turn off the system and attached peripherals, and disconnect the
system from the power source.
11 Remove the system-board assembly. See "Removing a System-Board
Assembly" on page 68.
12 If a diagnostic test or error message indicates a specific memory
module as faulty, swap or replace the module.
13 To troubleshoot an unspecified faulty memory module, replace the
memory module in the first DIMM socket with a module of the same
type and capacity. See "
Installing the Memory Modules" on page 85.
14 Install the system-board assembly. See "Removing a System-Board
Assembly
" on page 68.
15 Reconnect the system to its electrical outlet, and turn on the system
and attached peripherals.
16 As the system boots, observe any error message that appears and the
diagnostic indicators on the front of the system.