Filter
Top Products
Installing System Components | 93
Removing the RAID Battery Carrier
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
NOTE: The information in this section applies only to systems with the optional
RAID controller card.
1 Turn off the system, including any attached peripherals, and
disconnect the system from the electrical outlet.
2 Remove the system-board assembly. See “Removing a System-Board
Assembly” on page 68.
3 Remove the RAID battery. See “Removing the RAID Battery” on page
91.
4 Remove the three screws securing the RAID battery carrier to the
interposer extender. See Figure 3-18.
5 Replace the system-board assembly. See “Installing a System-Board
Assembly” on page 69.
6 Reconnect the system to the electrical outlet and turn the system on,
including any attached peripherals.