Filter
Top Products
96 Adding and Replacing Parts
www.dell.com | support.dell.com
4
Remove the hinge cover. See "Hinge Cover" on page 92.
5
Remove the four screws securing the display.
6
Disconnect the display cable, using the pull-tab.
7
Lift the display away from the computer at a 90-degree angle. Ensure that the antenna cables
and display cable are free from the routing channels and that the cables move freely when you
lift the display.
When you replace the display, ensure that the ribbon tape around the display cable is securely
tucked underneath the tabs. Insert the antenna wires through the hinge cover opening and then
through the hole in the system board. Ensure that the antenna wires are not twisted and that
they are securely attached to the Mini PCI card.
antenna
cables
screw (4)
display cable pull-tab
display cable connector
antenna cables