Dell R610 Server User Manual


 
Installing System Components 115
3
Disconnect the battery cable from the PERC controller. See Figure 3-17
for the battery connection location.
NOTE: Pay attention to the routing of the cable in the chassis for reinstallation.
4
Remove the battery cable from the cable clip on the system board nearest
PSU #2.
5
Follow the cable along the inside wall of the chassis.
6
Remove the fan bracket. See "Removing the Fan Assembly" on page 106.
7
Remove the fan cable from the plastic cable routing guide. It might be
necessary to remove other cables from the routing guide.
8
Disconnect the battery cable from the RAID battery.
Installing the PERC 6/I Battery Cable
1
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2
Open the system. See "Opening the System."
3
Remove the fan bracket. See "Removing the Fan Assembly" on page 106.
4
Connect the battery cable to the RAID battery.
5
Route the battery cable on the inside of the chassis wall through the plastic
cable routing guide. If any other cables were removed from the routing
guide, route those cables through the routing guide as well.
6
Route the cable on the inside of the chassis wall, place the cable in the
cable clip nearest PSU #2.
7
Route the cable to the PERC controller and connect it to the battery
connector on the PERC controller.
8
Replace the fan bracket. See "Replacing the Fan Assembly" on page 107.
9
Close the system. See "Closing the System."
10
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.