Filter
Top Products
104
BHT-7500W
SET WEP KEYx
1:KEY SIZE
40 128
2:KEY
ABCDE12345
Set up?
1:Yes 2:No
SET WEP KEYx
1:KEY SIZE
40 128
2:KEY
ABCDE123
Set error !
After making any change of settings, press the C
key with any item highlighted. The confirmation
screen will appear as shown at left.
To save the new entry, choose "1:Yes" and press
the ENT key. The "** Now Setting **" will appear
and the screen will return to the WEP KEY defini-
tion screen.
To cancel the new entry, choose "2:No" and press
the ENT key. The newly entered data will be
discarded and the screen will return to the WEP
KEY definition screen.
If you make no change, pressing the C key with
any item highlighted will return to the WEP key
definition screen.
When the "** Now Setting **" is displayed,
the new entry will be written onto the
EEPROM of the wireless module built in the
BHT-7500W.
While this message is displayed, do not turn
the BHT off. Writing halfway onto the
EEPROM will not bring any assured settings.
Be sure to record new entry you make. There
is no way to read it out from the EEPROM of
the wireless module.
As long as you do not set a new WEP key,
the previous setting will be retained.
To enable the encryption with an WEP key, you
need to set the "2:WEP" ON and choose the
SHAREDKEY in the "3:AUTHENTICATE" on the RF
option screen.
If any wrong WEP key is entered (e.g., the entered
key is not correct in length or it contains invalid
characters other than 0 through 9 and A through
F), then the error message will appear as shown at
left when you press "1:Yes" to save the new entry.
Enter the correct WEP key.
Defining WEP KEY 2 through 4
You may set WEP KEY 2 through 4 the same way as for WEP KEY1.