Filter
Top Products
modinfo
November 2009 156
If a raw G3 file has a 128-byte Brooktrout header (it is a btG3 file),
mktiff uses the resolution, width, and number of scan lines from the
header when storing the information for that page in the new TIFF
file. If it does not encounter a header or if the number of scan lines is
0, mktiff counts the actual number of scan lines in the G3 input file.
modinfo
The modinfo program lists information about active hardware and
software modules maintained within the driver.
The modinfo program is found in the bapp.src directory.
Command Syntax
modinfo [-p] [-c] [-s] [-h] [-H] [-a] [mod]
Each module found is listed, along with whatever hardware or
channel information is available. If a module has been marked by
the driver as dead, it is listed as *DEAD*.
Configuration values shown when using the -c option is supplied to
firm or firmload applications when downloading type 2 (PROC_APP)
firmware.
Configuration information from the module’s PCI configuration
space is displayed using the -p option.
The number of channels listed is the total number of channels
supported by the module, including its administrative channel. The
total is normally one more than the number of work channels, which
are mapped into ordinal channel numbers.
Argument
-p List PCI configuration information.
-c List firmware configuration options.
mod Module number whose status is to be
printed, otherwise all.
-s Display cPCI slot and CPU information.
-h Display hardware resource information.
-H Display the hardware information reported
by the firmware.
-a Use all previous options.