Filter
Top Products
Making Call Transfers Using Active Redirection (Japan)
November 2009 187
Making Call Transfers Using Active Redirection
(Japan)
To transfer calls in Japan, use Active Redirection, a call transfer
method that uses the central office or a PBX to transfer calls. Active
redirecting is only available for T1 ISDN PRI and ISDN BRI.
To configure using the
Brooktrout Configuration Tool (Windows® only):
Set port’s Protocol Options to T1 ISDN or BRI.
Set the network Protocol to JATE (Japan) INS-1500.
Set the network Switch Type to Japan.
Set the Transfer Variant to Jate ISDN.
Set the country_code in BTCall Parameters to 0810.
A list of country codes is in:
C:\Brooktrout\Boston\bfv.api\inc\ccode.h
Note: You must be in Advanced Mode in the Brooktrout Configuration
Tool
to configure BTCall Parameters.
To configure using configuration files:
Set the port configuration using the callctrl.cfg configuration file:
port_config=t1_isdn
Set the protocol using the callctrl.cfg configuration file:
protocol=ntt
Set the switch type using the callctrl.cfg configuration file:
switch_type=ntt
Set the transfer_variant using the callctrl.cfg configuration
file:
transfer_Variant=ntt
For ISDN BRI with point-to-multipoint configuration, set:
transfer_Variant=ntt_mp
Set the country code using the btcall.cfg configuration file:
country_code = 0810(Japan).
For more information on the Brooktrout Configuration Tool, refer to the
chapter on using the configuration tool in the installation and
configuration guide that came with your software.