Filter
Top Products
DI-304/DI-304M ISDN Remote Router
Appendix A – Troubleshooting and FAQs
The following section explains how to use Telnet terminal commands to diagnose
your network problems via the built-in debug tool. Our examples use Windows
Telnet client software. If you are a Mac user, you should install third-party Telnet
client software on your computer. By default, the Linux has a built-in Telnet client.
Using the Telnet Terminal Commands
Click Start → Run and type Telnet 192.168.0.1 in the Open box as below. Note
that the IP address in the example is the default address of the Router. If you have
changed the default, enter the current IP address of the router.
Click OK. The Telnet terminal will open. If an administrator password has not been
assigned, follow the on-screen instructions to assign one.
After assigning a password, type a question mark (?). You will see all the possible
Telnet commands.
83