D-Link DGS-3100 Switch User Manual


 
DGS-3100 Series Gigabit Stackable Managed Switch User Manual
Field Description
value.
Disabled — Disables re-authenticating the port or MAC addresses after the
port or MAC address authentication has timed out.
Control
Indicates the host status. If there is an asterisk (*), the port is either not
linked or is down. The possible field values are:
ForceUnauthorized — Indicates that either the port control is Force
Unauthorized and the port link is down, or the port control is Auto but a
client has not been authenticated via the port.
ForceAuthorized — Indicates that the port control is Forced Authorized,
and clients have full port access.
Auto — Indicates that the port control is Auto. The user has to
authenticate and get full access..
Unit
Indicate the stacking member for which the 802.1X parameters are defined.
From Port
Indicates the first port for which the 802.1X parameters are defined.
To Port
Indicates the last port for which the 802.1X parameters are defined.
Mode
Indicates the 802.1X mode enabled on the device. The possible field values
are:
Port Base — Enables 802.1X on ports. This is the default value.
MAC Base — Enables 802.1xon MAC addresses.
2. Enable or disable the 802.1X status in the 802.1X field.
3. Define the Mode field.
4. In the
802.1X Port Access Control section, define the fields.
5.
Set the ReAuthEnabled field and the Control fields.
6. Set the values in the Unit, From Port, and To Port fields.
7. Click . The 802.1x Access Control is configured, and the device is updated.
MAC Authentication (MAC-Based MAC Access Control)
MAC Authentication is configured in DGS-3100 series via ‘802.1x Setting’ WEB page.
This functionality enables the user to allow specific MAC address to enter the switch while rejecting the unauthorized MAC
addresses. The database of the authorized MAC addresses resides in a Radius Server.
NOTE: The system does not support dynamic VLAN assignment within mac-based authentication
via the radius server.
NOTE: MAC-based authentication doesn't require 802.1X client enabled.
101