Filter
Top Products
System and Control Options
74
7.11.2 Set Up Mapping for an Analog Sensor Input
• Use the arrows ↑↓ to choose Map Sensor To Relay from the Map
Input/Sensor Menu, and press Enter ↵.
• From the Select Sensor Menu, choose the input you want—for
example, Sensor_1 High Stpt—and press Enter ↵.
Map Sensor to Control Relay
• On the Sensor-to-Relay Map screen, you may map the selected sen-
sor to either or both of the control relays (1-2). The example at right
shows Sensor_1 High Stpt mapped to Control Relay 1.
To make changes to the mapping:
• If needed, press Enter ↵ to advance to the position directly
below the relay.
• Use the arrows ↑↓ to choose Y (Yes - Mapped to this relay) or
N (No - Not mapped), then press Enter ↵.
• Press Enter ↵ to advance to the next position where you want
to make a change.
• Use the arrows ↑↓ to choose Y (Yes - Mapped to this relay) or
N (No - Not mapped), then press Enter ↵.
• When finished, press Enter ↵ again.
Default Mappings - Analog Inputs to Control Relays
By default, analog inputs are not mapped to any control relay, as
shown in Table 31.
Table 31 Default mapping of analog inputs to relays
Analog input By default, mapped to control relay:
Sensor_1 (none)
Sensor_2 (none)
Sensor_3 (none)
Sensor_4 (none)
Map Input/Sensor Menu
MAP INPUT TO RELAY
> MAP SENSOR TO RELAY
↑↓=NEXT
↵=SELECT
Select Sensor
SELECT SENSOR
> SENSOR_1 HIGH STPT
SENSOR_1 LOW STPT
↑↓=NEXT ↵=SELECT
SENSOR_2 HIGH STPT
SENSOR_2 LOW STPT
SENSOR_3 HIGH STPT
SENSOR_3 LOW STPT
SENSOR_4 HIGH STPT
SENSOR_4 LOW STPT
Sensor-to-Relay Map
1H CONTROL RELAY
1 2
Y
N
↑↓=Y/N ↵=NEXT/END