Filter
Top Products
q
The following screen showing the status of image signals is displayed
when only the image that the projector is currently displaying is
available, or when no image signal can be found. You can select the
input port where the equipment you want to use is connected. If no
operation is performed after about 10 seconds, the screen closes.
Switch to the target image by Remote Control
You can change directly to the target image by pressing the following
buttons on the Remote Control.
Remote Control
A
Each time you press the button, input changes between images from the
Computer1 input port and the Computer2 input port.
B
Each time you press the button, input changes between images from the
Video input port and the S-Video input port.
C
Each time you press the button, input changes between images from the
equipment connected to USB Display and USB(TypeA) port.
D
Changes to the images projected with EasyMP Network Projection. When
you are projecting via Quick Wireless Connection using the optional Quick
Wireless Connection USB Key, this button changes to that image.
Changing the Projected Image
22