Filter
Top Products
27
Preparation for Using Cinema Color Editor
Adjusting projected images using a computer
TW500_English
Setting details
Set the following items depending on the network environment that is used.
The settings for the computer will vary depending on the operating system being used. Refer to the
computer documentation for details on the setting method.
When connecting directly to a computer
When connecting to a computer that is permanently connected to the Internet
If changing a numeric value, a cursor will be displayed, so use and to move the cursor to the
value to be changed and use and to display the desired value.
Once the desired value is displayed, press
to accept the setting.
DHCP
Set DHCP to "OFF".
IP Address
Enter a private IP address.
Example: 192.168.0.1 – 192.168.255.254
Set an IP address that does not overlap with the computer's IP address.
Subnet Mask
For example, set to 255.255.255.0.
Gateway
Address Enter the same address as the computer's IP address.
SNMP Trap IP Address 1/2
Two IP addresses can be set as notification addresses for SNMP traps.
To use the SNMP function to monitor the projector, you will need to have an
SNMP manager program installed on the computer. Ask the network
administrator to do this step.
If a notification cannot be sent to the IP address that has been set for "SNMP
Trap IP Address 1", then it is sent to the IP address that has been set for
"SNMP Trap IP Address 2".
MAC Address
This shows the MAC address for the projector.
Projector Name
This shows the individual name used for the projector to identify it on the network.
DHCP
Set DHCP to "ON".
If the DHCP function cannot be used or if assigning a static IP address, select "OFF".
IP Address
If "DHCP" is set to "ON", these items are set automatically, and so you do not
need to set them yourself.
If "DHCP" is set to "OFF", enter the address specified by your Internet Service
Provider.
Subnet Mask
Gateway Address
SNMP Trap IP Address 1/2
Two IP addresses can be set as notification addresses for SNMP traps.
To use the SNMP function to monitor the projector, you will need to have an
SNMP manager program installed on the computer. Ask the network
administrator to do this step.
If a notification cannot be sent to the IP address that has been set for "SNMP
Trap IP Address 1", then it is sent to the IP address that has been set for
"SNMP Trap IP Address 2".
MAC Address
This shows the MAC address for the projector.
Projector Name
This shows the individual name used for the projector to identify it on the network.
The following software is provided to allow you to monitor and control the status of
projectors over a network.
•
EMP NetworkManager: You can set destination addresses for the "Mail Notification
function" to use for sending e-mail messages to notify the computer operator when a
problem occurs with a projector.
•
EMP Monitor: This lets you monitor the status of more than one projector on the
network and to run batch operations such as turning projector power on and off and
changing signal sources from a computer's monitor screen.
For details on acquiring the software, please visit the following web site:
http://www.epson.co.uk/support/download/
TW500-E.book Page 27 Wednesday, October 29, 2003 8:52 PM