Filter
Top Products
Image Optimum
Reduces the amount of graphics data when the data reaches the
memory limit, allowing complex documents to be printed.
When this mode is on, graphics quality is reduced.
Paper Type
Allows you to use various types of paper.
Thin
is useful for the
regular size plain paper under 75g/m
2
.
Thick
is useful for
irregular size plain paper over 75g/m
2
and envelopes that are
less than 257mm wide.
Trnsprnc
is useful for transparencies.
Paper Type usually works best if set to
Normal
.
Setup Menu
Interface
Specifies whether the printer can receive data through all the
interfaces available or only through the one selected.
Time Out
Sets the length of time the printer waits when it is on line and
no new data is received. When this time is up, the printer
searches for new print data on other channels.
Standby
Saves power by reducing the power to the fixing heater if the
printer receives no data for 60 minutes. In this mode, the
printer begins warming up as soon as you press send print
data; it then warms up and is ready to print in about 70
seconds.
Lang
Specifies the language displayed on the control panel and
printed on the status sheet.
R
Albatross Rev. c
A5 size Chapter 5
96/08/23 Pass 0, DR
SelecType
5-15