Filter
Top Products
❑
Current Loop Cable C836141 (0.4 m) from mini DIN
(printer) to D-SUB 25-pin (interface cable) for both RS-232C
and Current loop; a cable extension for printer to interface
cable connection
If you installed a serial interface, you need to ensure that the
printer and the computer are using the same serial settings. If
the serial settings do not match, you must make the
appropriate settings. The settings can be changed either in the
printer or computer. See the next section for information about
the serial interface utility that comes with your printer.
The default serial settings for the optional serial interface are
listed below. To change the serial settings, see the interface
card’s manual if you are using a Type-B serial interface or if
you installed a LocalTalk/Serial module. For information
about your computer’s serial settings, see your computer
manual.
Serial type: RS-232C
Word length: 8
Baud rate: 9600
Parity: NONE
Stop bit: 1
DTR: OFF
XON/XOFF: ON
You also need to change the port setting of your computer if it
is not already set to the serial port. The following procedures
describe how to change the port setting in Windows 3.1,
Windows 3.11 for Workgroups and Windows 95. To change the
setting using non-Windows software, see your software
manual.
R
Albatross Rev.c
Reference Guide
A5 size Chapter 3
’96/08/23 DR, pass 0
Options
3-27