Filter
Top Products
LJ4 Menu
Note:
If you always use the HP LaseJet 4 printer driver in your software,
you should change settings using your software. The software settings
always override the LJ4 menu options.
FontSource
Selects the default font source.
Font Number
Selects the default font number from the default font source.
Pitch
Specifies the default font pitch if the font is scalable and
fixed-pitch. You can select from 0.44 to 99.99 CPI, in increments
of 0.01 CPI.
Height
Specifies the default font height if the font is scalable and
proportional. You can select from 4.00 to 999.75 points, in
increments of 0.25 points.
SymSet
Selects the default symbol set. If the font you selected in
FontSource
and
Font Number
is not available in the new
SymSet setting, the Fontsource and the Font Number values are
automatically replaced with the default value.
Form
Selects the number of lines for the selected paper size and
orientation. This causes a line spacing (VMI) change also, and
the new VMI value is stored in the printer. This means that
later changes in the Page Size or the Orientation settings cause
changes in the Form value, based on the stored VMI.
R
Albatross Rev. c
A5 size Chapter 5
96/08/23 Pass 0, DR
SelecType
5-19