Filter
Top Products
EPSON GL/2 Mode
Note:
You cannot change the GL/2 Mode items by SelecType. To change
these items, use the GL/2 command listed in Appendix C.
In EPSON GL/2 mode, you can use your printer with plotter
applications. EPSON GL/2 has two operational modes. One is
the LJ4GL2 mode; the other is the GLlike mode. The GLlike
mode emulates some of the HP-GL plotter commands and
includes all of the commands found in LJ4GL2 mode, plus two
additional commands.
The table below shows the differences between these modes.
For more information on GL/2 commands in LJ4 emulation
mode, see Appendix C.
Command LJ4GL2 mode GLlike mode
Orientation Printer setting Landscape only
Plotter unit 1/1016 inch 1/1021 inch
Picture frame Same as LaserJet 4
mode
Depends on the
hard-clip limit
Default position of P1
and P2
Lower left and
lower right corners,
respectively, of
picture frame
inside of picture frame
Undefined
commands
First character is
ignored
First two characters
are ignored
CS, CA commands Not supported Partially supported
PG, AF commands Not supported Supported
Results when a DT
command with no
second parameter is
sent
Terminator is not
plotted
Terminator is plotted
ESC %#A commands Supported Not supported
L
Albatross Rev. c
A5 size Chapter 5
96/08/23 Pass 0, DR
5-28
SelecType