Filter
Top Products
Using the Projector
31
Using the Remote Control
The remote control lets you access projector features from anywhere
in the room—up to 32 feet away. You must also be within a 30°
horizontal and a 15° vertical angle of the infrared receiver on the front
of the projector.
You can use the remote control to turn the projector on and off, zoom
the image, display the projector menus, and other uses.If you
connected a mouse cable to the projector, you can also use the remote
control as a wireless mouse to run your presentation. See page 32 for
instructions.
Installing the Remote Control Batteries
The remote control operates the projector and lets you access its setup
menus. You can also use it as a wireless mouse.
Follow these steps to install the
batteries:
1. Press the tab to release the battery
cover and lift it up to remove it.
2. Insert the two AA batteries
included with the projector
as shown.
3. Replace the battery cover.
infrared receiver
for remote control
note
You can aim the remote
control at your projection
screen and reflect the signal
back into the sensor on the
front of the projector, but this
shortens the operating
distance of the remote
control.
caution
When replacing batteries,
take the following
precautions:
■
Replace batteries as soon
as they run out.
■
Do not mix old and new
batteries.
■
If the batteries leak, wipe
away battery fluid with a
soft cloth. If fluid gets on
your hands, wash them
immediately.
■
Remove batteries if you
will not be using the
remote for a long period
of time.