Filter
Top Products
Using the Control Panel 39
Default-setting mode
Follow the steps below to enter default-setting mode. If single-sheet
paper is loaded, you’ll need to load a new sheet each time the printer
ejects a printed page.
1. Make sure the printer is on and paper is loaded. Then press the
Menu buttons (ItemU and Set) until the printer beeps and both the
Menu lights turn on.
The printer enters default-setting mode and prints a line showing
which language is currently selected for printing the instructions.
(The selected language is underlined.)
Software ESC/P, IBM PPDS
0 slash 0,
I/F (interface) mode Auto, Parallel, USB, Option
Auto I/F wait time 10 seconds, 30 seconds
Parallel I/F bidirectional
mode
Off, On
Packet mode Auto, Off
Auto CR (available in IBM
PPDS emulation mode)
Off, On
A.G.M. (IBM PPDS);
available in IBM PPDS
emulation mode
Off, On
Character table Italic, PC 437, PC 850, PC 860, PC 863, PC 865, PC 861,
BRASCII, Abicomp, Roman 8, ISO Latin 1, PC 858,
ISO 8859-15
International character
set for italic table
Italic U.S.A., Italic France, Italic Germany, Italic U.K.,
Italic Denmark 1, Italic Sweden, Italic Italy, Italic Spain 1
Font OCR-B, Orator, Orator-S, Script C, Roman T, Sans serif H
Manual feed wait time 1 second, 1.5 seconds, 2 seconds, 3 seconds
Buzzer Off, On
Roll paper Off, On
IBM character table Table 2, Table1
Low-noise mode Off, On
Setting Options (default in bold)