Filter
Top Products
5-10
Changing Printer Settings From the Printer’s Control Panel
Changing default settings
Follow the steps on the next page to enter the default-setting mode
and change the printer’s default settings.
Note:
❏
To print the language selection and default-setting mode
instructions, you need five sheets of A4 or letter size single-sheet
paper, or five pages of continuous paper that is at least 279 mm (11
inches) long and 210 mm (8.27 inches) wide. See Chapter 2 for
instructions on loading continuous paper, or Chapter 3 for
instructions on loading single sheets.
❏
If you use single sheets, you need to load a new sheet of paper each
time the printer ejects a printed sheet.
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.
2. While holding down the
Font
button, turn on the printer. The
printer enters the default-setting mode and prints the
language selection instructions.
3. Press the
Font
button until the Font lights indicate the
language you want, as described in the language selection
instructions.