Filter
Top Products
Control Panel Buttons and Lights
n = On
f = Flashing
o = Off
Tear Off/Bin button
●
Advances continuous paper to the
tear-off position.
●
Feeds continuous paper backward
from the tear-off position to the top-
of-form position.
●
Selects a cut-sheet feeder bin when
the cut-sheet feeder is installed.
●
Turns on the card mode to print on
postcards and envelopes. See
Chapter 3.
Tear Off/Bin lights
●
f f
when continuous paper is in the
tear-off position.
●
o n
when bin 1 of the optional cut-
sheet feeder is selected.
●
n o
when bin 2 of the optional cut-
sheet feeder is selected.
●
n n
when the printer is in the card
mode.
*Micro Adjust mode
When you hold down the Pause button for three
seconds, the printer enters the micro adjust mode. In
this mode, you can press the LF/FF
D
and Load/Eject
U
buttons to adjust the top-of-form or tear-off position.
See Chapter 2.
Pause button
Stops printing temporarily,
and resumes printing
when pressed again.
When pressed for three
seconds, turns on the
*micro adjust mode. To
turn off, press again.
Pause light
●
On when the printer is
paused.
●
Flashes when the
printer is in the *micro
adjust mode.
●
Flashes when the print
head has overheated.
Font button
Selects the font.
See Chapter 5.
Font lights
Indicate which
font is selected.
Paper Out light
●
On when no paper is
loaded in the
selected paper
source or paper is not
loaded correctly.
●
Flashes when paper
has not been fully
ejected or a paper
jam has occurred.
LF/FF button
●
Feeds paper line by
line when pressing
shortly.
●
Ejects a single sheet
or advances
continuous paper to
the next top-of-form
position when held
down.
Load/Eject button
●
Loads a single sheet of
paper.
●
Ejects a single sheet of
paper if a sheet is
loaded.
●
Loads continuous paper
from the standby
position.
●
Feeds continuous paper
backward to the
standby position.
Condensed button
Turns on and off the
condensed mode.
Condensed light
Lights up when the
condensed mode is
on.