Filter
Top Products
Basic Operations 116
Media Adjust
This menu is used to adjust media when Auto Media Adjust cannot be used or when
reconfiguring media settings is required due to a change in printing conditions after saving
the media settings. In this menu, perform Feed Adjustment and Head Alignment
individually.
❏ Media adjustment when Auto Media Adjust cannot be used
When you cannot adjust media using Auto Media Adjust or when banding or
graininess is detected in printing results even after Auto Media Adjust has been
performed, select Feed Adjustment - Manual and Head Alignment - Standard
(Manual) to take appropriate actions.
❏ Media adjustment when changing printing conditions after saving media settings
After saving media settings, select Feed Adjustment - Auto in any of the following
situations:
❏ The Media Tension or Media Suction setting has been changed in Advanced
Settings
❏ Counterweights have been attached to or detached from the tensioner
❏ The standard media unit and the optional heavy roll media system have been
switched
❏ The configuration of pressure rollers has been changed (S70675, S50675)
When Platen Gap has been changed, select Head Alignment - Standard (Auto) in this
menu. However, if the setting value is changed to 2.5, auto adjustment becomes
unavailable. Perform Standard (Manual).
Change the setting values of the following items before executing this menu:
❏ Platen Gap
❏ Advanced Settings
See “Customize Settings” on page 204.