Filter
Top Products
Basic Operations 93
❏ Attach media to the roll core using the paper tape supplied. Using the paper tape
reduces take-up roll misalignment errors. When the tape has been completely used,
purchase commercially available paper tape (that is not easily stretched or cut) with a
width of 20 to 25 mm (about one inch).
❏ For ink layering, the auto take-up reel unit is not recommended (S70675 and S50675
only). Take-up may not be possible, or print quality may decline.
Attaching the Roll Core
1. After confirming that the media is loaded correctly, press the d button until the leading
edge of the media reaches the roll core holder.
2. Loosen the roll core holder fixing screws at both sides and adjust the left roll core
holder.
Important:
When using the optional heavy roll media system and before starting this procedure, check
that the handle shaft of the unit on the left is visible. If the shaft is not visible, turn the
handle in the direction shown below unit it does not turn any more.
Important:
Always press the d button to feed the media as far as the roll core holder. If the media is
pulled by hand, the media may twist during take-up.