Filter
Top Products
Basic Operations 53
20.Close the front cover.
When using the auto take-up reel, see “Using the Auto Take-up Reel Unit” on page 92.
When not using the auto take-up reel, proceed to check the media and change settings.
See “Viewing and Changing Media Settings” on page 85.
Using the optional heavy roll media feeding unit
This section uses the S70675 to illustrate how to load media when the optional heavy roll
media feeding unit is installed.
The explanation that follows assumes that a lifter is used.
The following types of lifter can be used:
❏ Fork or platform thickness: 28 mm (1.10 inches) or less
❏ The fork or platform can be lowered to approximately 190 mm (7.5 inches) from the
floor.
Before loading, be sure to read “Notes on Loading Media” on page 38.
1. Turn on the printer and wait until Load media appears on the screen.
2. Open the front cover and move the media holding plates out of the way.
c
Caution:
Because the media is heavy, it should not be carried by one person. When loading or
removing the media, use at least two persons. Using a lifter is recommended when
handling a media that is 40 kg (88.3 lb) or heavier.
Important:
When spot color inks are installed, circulation will be performed automatically to prevent ink
accumulating in the printer and causing clogs when the printer is not in use. Because
turning the printer off prevents automatic circulation from being performed, leading to
printer malfunction, we recommend that the printer not be turned off.