Filter
Top Products
Basic Operations 128
3 Note the following points when setting margins:
Leave margins of 10 mm (0.4 inch) or more when using media holding plates. Narrower margins could result in printer
printing over the plates.
If the total of the print data width and set left and right margins exceeds the printable area, a portion of the data will not
be printed.
Note:
If the following points are not observed when Media Size Check is Off, printing may occur
outside the left and right edges of the media. Ink used outside the edges of the media will
stain the inside of the printer.
❏ Ensure that the print data width does not exceed the loaded media width.
❏ When media is loaded to the left of the right side reference position, align the Print Start
Position setting with the position where the media is set. See “The Printer Setup Menu”
on page 208.