Filter
Top Products
EPSON AcuLaser C1100 Revision B
TROUBLESHOOTING FIP according to the printer message 130
3.3.2 List of Service Request
Table 3-3. List of Service Request
Class Panel Messaeg Description See FIP
Engine Related (E)
Service Req E510 ROS Motor Failure
44 (p.197)
PWBA MCU could not receive signals output from SOS Sensor in ROS within the specified time.
Service Req E511 TR0 Failure
43 (p.195)
PWBA MCU could not receive signals output from SENSOR TR-0 (TR0 Sensor) at the specified timing.
Service Req E513 NVRAM Error
42 (p.194)
An error occurred in NVRAM on PWBA MCU.
Service Req E514 PAGE Timeout
41 (p.194)
The PAGEC/PAGE signal was not received within 60sec after transmitting PFA.
Service Req E516 Communication Error Duplex
40 (p.193)
A communication error occurred between PWBA MCU and Duplex.
Service Req E517 Communication Error Feeder
39 (p.192)
A communication error occurred between PWBA MCU and Feeder.
Service Req E520 BTR 2 Advance Error
52 (p.208)
The 2nd BTR Retract Sensor does not turn ON within the specified time.
Service Req E521 BTR 2 Error
51 (p.206)
The input of 2nd BTR Retract Sensor does not change when 2nd BTR is initialized.
Service Req E523 PCDC Error
49 (p.204)
PCDC is not functioning normally.
Service Req E524 Low Density
48 (p.202)
The output value of SENSOR ASSY ADC (ADC Sensor) is below the specified value.
Service Req E525 High Density
47 (p.200)
The output value of SENSOR ASSY ADC (ADC Sensor) exceeds the specified value.
Service Req E526 ADC Contamination
46 (p.199)
SENSOR ASSY ADC (ADC Sensor) error