Filter
Top Products
The printer loads more than one sheet at a time.
Cause What to do
Too many sheets are loaded
in the sheet feeder.
Take the paper stack out of the feeder,
remove some sheets, and reload the
stack. Load paper only up to the arrow
mark on the left edge guide.
The edge guides are not set
correctly.
Adjust the guides against the stack of
paper. See “Loading Paper” in
Chapter 2.
The paper is too thin. Make sure the paper meets the paper
requirements for this printer. See
“Paper” in Appendix B.
Ejected paper is wrinkled.
Cause What to do
The paper is too thin or damp. Do not store your paper in a damp or
humid environment. Store paper in its
original packaging.
Paper does not fully eject.
Cause What to do
The paper is too long. Press the load/eject button to eject
the paper. Use paper that meets the
paper requirements for this printer.
See “Paper” in Appendix B.
L
Hawaii2 Ref. Guide
Rev.b
A5 size Chapter 6
06-02-97 DR, pass 0
6-14
Troubleshooting