Filter
Top Products
A
Power connector — Connect the provided 12 V, 1 A power supply to this 2-pole
captive screw connector (see Wiring the Power Connector on page 8).
ATTENTION:
• Do not connect power to the unit until you have read the CAUTION and
ATTENTION notices on page 8.
• Ne branchez pas l’alimentation au l’unité avant d’avoir lu les mises en garde
CAUTION et ATTENTION de la page 8.
B
HDMI Input connector — Connect an HDMI source to this female HDMI input
connector. Secure the HDMI input to the HDMI connector using the LockIt bracket
(see “Securing the HDMI Connector using the LockIt Bracket”).
C
LockIt mounting screws — Use these screws to attach each LockIt lacing bracket
to the HDMI connector below it (see “Securing the HDMI Connector Using the LockIt
Bracket,” below).
D
HDMI Output Connector — Connect an HDMI display device to this female HDMI
output connector. Secure the HDMI output to the HDMI connector using the LockIt
bracket (see “Securing the HDMI Connector using the LockIt Bracket”).
Securing the HDMI Connector Using the LockIt Bracket
After connecting an input or output device to an HDMI connector, secure the connector in
place with the provided LockIt bracket as follows:
1. Plug the HDMI cable into one of the rear panel
|HDMI connectors.
2. Loosen the mounting screw directly above the
HDMI connector enough to allow the LockIt lacing
bracket to be placed above it.
3. Place the LockIt lacing bracket onto the screw and
slide it down against the HDMI connector. Tighten
the screw to secure the bracket.
4. Loosely wrap the included tie wrap around the
HDMI connector and LockIt lacing bracket.
5. While holding the connector securely against the
lacing bracket, tighten the tie wrap, then remove
any excess length.
6. Repeat steps 1 through 5 for the other HDMI
connector.
OUTPUT
3
1
2
3
4
DSC HD-HD • Installation 5