Filter
Top Products
NOTES:
• The Audio Test pattern displays a crop pattern with AUDIO TEST in a
bouncing text box. It also outputs pink noise at 48 kHz, 24 bit.
• By default all test patterns include a single pixel wide crop pattern line.
• Screen Saver and Timeout — This option lets you enable screen saver mode,
in which the video output is muted to black or blue if there is no active input video
signal. It also lets you specify the output sync timeout. Screen saver mode allows
display devices (such as an LCD panel, plasma screen, or projector) to enter low
power or standby state to increase panel or lamp life.
• To select the screen saver color, press the t or button. The options are Black
(default) or Blue.
• To set the sync timeout from the Advanced submenu, press the
or button.
You can select a duration of 0 through 500 seconds before the output sync times
out. The default is Never, meaning that the sync does not time out.
NOTE: The DSC exits screen saver mode when a front panel button is pressed or
an active input is detected. If the unit is in front panel lock (executive) mode (see
Locking the Front Panel (Executive Mode) on page 20), front panel button
presses have no effect on screen saver mode.
• Factory Reset — This option lets you reset the unit to its factory-installed values
(removing any user-defined values) while retaining the current firmware version.
To reset using the OSD:
1. Select Factory Reset from the Advanced submenu and press Enter.
2. Press and hold the Enter button as instructed by the prompt until Factory Reset
is displayed in a text box. The message remains for approximately 1 minute after
the reset is complete to allow time for the display device to sync with the DSC
output. (The equivalent SIS command is
E
zxxx
]
.) For other reset methods,
see Resetting the Unit on page 20.
DSC HD-HD • Operation 18