Filter
Top Products
DVS 510 Series • Operation 43
Output Sync Mute
This function mutes all video and sync outputs, placing the display device in a power
save mode. Output sync mute is available only via SIS commands (see the Video Mute
commands on page 57, in the Command and Response Table for SIS Commands).
NOTE: Individual outputs cannot be muted by this command. With the output sync
mute enabled, all analog and digital outputs are simultaneously disabled.
Overscan Mode
This function allows you to set a default overscan of 0%, 2.5%, or 5% to apply to SMPTE
input rates (NTSC, PAL, 480p through 1080p). When the overscan mode is not set to 0%
and an auto-image is performed on a low-resolution or DVI input, the DVS uses the default
values for input sizing and centering instead of performing a complete auto-image.
For YUV Auto and RGB inputs, pixel phase is included in the auto-image, regardless of the
current overscan setting.
The overscan mode setting is adjusted per input type (composite, S-video, RGBcvS,
YUV Auto, RGB, and DVI) using SIS commands (see the Overscan Mode commands on
page 64 in the Command and Response Table for SIS Commands).
Using the Optional IR 904 Remote Control
The optional hand-held IR 904 Remote Control (part number 70-767-01) provides a
convenient means of remotely performing many of the functions that are also available
through the front panel, SIS commands, the Windows-based control software, or the
embedded web pages. The DVS responds to commands from remote control as if the
corresponding button were pressed on the front panel or the corresponding SIS command or
software selection were entered.
The IR receiver port on the front panel is located to the left of the Config port. It receives
signals from the remote control if they are sent from within a 40-degree arc to the right or
left of direct line of sight between the remote control and the scaler IR sensor, and from no
more than 30 feet (9 m) away.
DVS 510
DIGITAL VIDEO SCALER
MENU
NEXT
DETAIL
ZOOM
/PAN
BRIGHT
/CONT
COLOR
/TINT
SIZE
POSITION
PIP
ON/OFF
PIP
SWAP
CONFIG
IR
MAX
MID
MIN
10
1234
6789
5
ADJUST
VOLUME
PICTURE CONTROLS
PIP
INPUTS
DVS 510 Series Scaler
40 40
30’ (9.1 m)
maximum
IR 904 Remote Control
PIP
VOLUME
4321
IR 904
REMOTE
ON/OFF
SWAP
INPUT SELECTION
AUTO
IMAGE
POSITIONSIZE
COLOR
CONT
DETAIL
ADJUST
8765
109
PAN
ZOOM
A/V
MUTE
VIDEO
MUTE
AUDIO
MUTE
IMAGE ADJUSTMENTS
+
-
TINT
+
-
+
-
BRIGHT
FREEZE
+
-
+
-
Figure 24. Area for Remote Signal Reception