Filter
Top Products
DVS 510 Series • HTML Configuration and Control 93
Fig_Test Patterns
Alt Pixels
4x4 Crosshatch
Crosshatch
Grayscale
Color Bars
Ramp
Crop
1.78 Aspect
1.85 Aspect
2.35 Aspect
1.33 Aspect
White Field
Blue Mode
Figure 44. Test Patterns on the DVS 510
The default is Off (no test pattern). (See “Test Pattern submenu” on page 32 for more
information on using test patterns.)
• Auto Memories: Select On or Off to enable or disable auto memories. When auto
memories are activated, the DVS stores size, position, and picture settings based on
the incoming signal from the connected input. When the same input signal is detected
again, these image settings are recalled from memory and applied.
• Switch Effect: Select the effect that is displayed when inputs are switched. Cut
immediately replaces the image from the current input with the image from the new
input; Fade causes the current input to fade to black while the new input fades in
(default).
• Aspect Ratio: Select Fill (the input signal at each rate fills the entire output raster),
or Follow (the input signal at each rate is displayed with its native aspect ratio [default
setting]). (See “Aspect Ratio submenu” on page 31 for more information about these
fill modes.)