Filter
Top Products
DVS 510 Series • Remote Configuration and Control 65
Command
ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Advanced Configuration (continued)
HDCP Signal Status
Query input
E I HDCP } X4$ ]
Request the HDCP signal status of the
current input.
Query output
E O HDCP } X4$ ]
Request the HDCP signal status of the
DVI output.
Video Switch Effect
NOTE: The video switch effect also affects the audio switch, as discussed in the following command descriptions.
Cut
E 0 SWEF } Swef 0 ]
Set the video switch effect to cut. The
audio output is instantly switched to the
next input.
Fade
Swef 1 ]
Set the video switch effect to fade
(default). The audio ramps down from
the current input, then ramps up to the
new input.
View effect
E SWEF } X4% ]
Show the current switch effect.
IR Receiver
Enable receiver
65 * 1 #
IRDisable 1 ]
Enable the IR receiver on the
DVS front panel.
Disable receiver
65 * 0 #
IRDisable 0 ]
Disable the IR receiver (default).
View IR receiver status
65 #
X1) ]
View IR receiver status.
Information Request
General information
I
Vid X! • Aud X! • Pip X! • Typ X# • Std X1! ]
View the following device information:
Vid = video input
Aud = audio input
Pip = PIP input
Typ = video signal type
Std = video standard (X1!)
Query firmware version
Q
n.nn ]
View the current rmware version.
Query part number
N
60-835-nn ]
DVS 510 = 60-835-01
DVS 510 SA = 60-835-02
View internal temp.
E 20STAT } X1@ ]
View the internal temperature in degrees
Celsius (response contains leading zeros).
NOTE: X! = Input selection 1 through 10
X# = Input signal type 1 = RGB, 2 = YUVp/HDTV, 3 = RGBcvS, 4 = YUVi, 5 = S-video, 6 = Composite,
7 = DVI
X1) = IR receiver status 0 = IR receiver disabled; 1 = IR receiver enabled
X1! = Input video standard 0 = No signal, 1 = NTSC 3.58, 2 = PAL, 3 = NTSC 4.43, 4 = SECAM
– = Not applicable (occurs when the input is set to RGB or YUVp/HDTV)
X1@ = Internal temperature Shown in degrees Celsius with leading zeros
X4$ = HDCP signal status 0 = No receiver or source device detected (analog or digital inputs or outputs)
1 = Receiver or source detected with HDCP/DPCP (digital inputs or outputs only)
2 = Receiver or source detected but no HDCP/DPCP is present (analog or digital
inputs or outputs)
X4% = Video switching effect 0 = Cut. Instantly switches audio output to the next input.
1 = Fade. Audio ramps down from the current input, then ramps up to the new
input (default).