Extron electronic IPI 100 Switch User Manual


  Open as PDF
of 86
 
Initia Conguration, cont’d
IPI 100 and IPI 200 Series • Initial Conguration
4-4
Setting the IP address using embedded Web pages
EachIPI200Seriesintercomunitcontainsanon‑boardWebserverwithinteractive
pages that can be used to configure the device.
The intercom unit must be at its factory default IP address.
TosetanIPaddressviaembeddedWebpages:
1. Connect an Ethernet crossover cable between the device and a local PC.
2. OnthePC,locatetheTCP/IPPropertiesdialogbox.
OnWindowsXP,theTCP/IPPropertiesdialogboxisfoundat:
Start > My Network Places>right‑clicktoProperties > Local Area
Connection > right-click to Properties > Internet Protocol (TCP/IP) >
Properties.
3
. Record the current IP address, subnet mask, default gateway and DHCP
settings. You will need this information later to return the PC to its original
TCP/IPsettings.
IP Address:
. . .
SubnetMask:
. . .
4. Enter the following:
 IPaddress:192.168.254.253
 Subnetmask:255.255.0.0
 Defaultgateway:<blank>
5. Click OK.
6. OpenaWebbrowseronthelocalPC.
7. Enter192.168.254.254inthebrowser’sAddresseldandpresstheEnterkey.
Theintercomunit’sembeddedWebpageisdisplayed.
8. Click the Configuration tab.
 previous next