Extron electronic IPI 100 Switch User Manual


  Open as PDF
of 86
 
SIS Programming and Contro, cont’d
IPI 100 and IPI 200 Series • SIS Programming and Control
B-4
Commands and Reponses
Using the command/response tabe
TheIPI201/204SeriesintercomcanbecontrolledviaeitheraTelnet(port23)
orRS‑232connectionusingASCIIcommands.OritcanbecontrolledviaaWeb
browser(port80)connectionusingURL‑encodedcommands.TheASCIIandURL
commandslistedinthetablestartingonpageB‑8performthesamefunctions,but
they are encoded differently to accommodate the requirements of each port (Telnet
or browser).
TheASCIItohexadecimal(HEX)conversiontableshownbelowisforusewiththe
command/responsetables.
ASCII to HEX Conversion Table
Space
.
Thecommand/responsetablelistsvalidASCII(forTelnetorRS‑232)command
codes,thecorrespondingURL(uniformresourcelocator)encoded(forWeb
browsers)commandcodes,theIPI’sresponsestothehost,andadescriptionofthe
command’sfunctionortheresultsofexecutingthecommand.
• Upperandlowercasecharactersmaybeusedinterchangeablyinthecommand
field unless otherwise specified.
• Commandsmaybesentback‑to‑backwithoutspaces(forexample,11S0X4Q).
• Numberscanbeenteredwithleadingzeroes,as1,2,or3digits.
• Thereareafewdifferencesinhowtoenterthecommandsdependingon
whetheryouareusingTelnetoraWebbrowser.
o WhenusingthesecommandsthroughaWebbrowser,theURLreference
isusedtoshortentheexamples.“URL”referstothefullURLofthe
intercomandWebpagereferenceincludingallpathinformation(e.g.,
http://192.168.100.10/myform.htm).
o TosendanyofthecommandsusingaWebbrowseryoumustprexthem
with the full URL followed by ?cmd=.
 previous next