Extron electronic IPI 100 Switch User Manual


  Open as PDF
of 86
 
B-3
IPI 100 and IPI 200 Series • SIS Programming and Control
• IftheIPIison,itsendsthebootandcopyrightmessageswhenyourstopen
a Telnet connection to the IPI. You can see the day of the week, date, and time
iftheIPIisconnectedviaTelnet,butnotviaRS‑232.IfyouareusingaTelnet
connection, the copyright message, date, and time are followed by a password
prompt.
Additional messages may be sent by the IPI in response to front panel selections
and volume adjustments and when scripts are executed during scheduled events.
Password information
The“
]
Password:”promptrequiresapassword(administratorleveloruserlevel)
followed by a carriage return. The prompt is repeated if the correct password is not
entered.
Ifthecorrectpasswordisentered,theunitrespondswith“
]
Login Administrator
]
”
or“
]
Login User
]
”,dependingonthepasswordentered.Ifpasswordsarethesame
for both administrator and user, the unit will default to administrator privileges.
Error responses
WhentheIPIreceivesavalidSIScommand,itexecutesthecommandandsendsa
response to the host device. If the IPI is unable to execute the command because
the command is invalid or it contains invalid parameters, it returns an error
response to the host.
The error response codes and their descriptions are as follows:
E12 – Invalid port number
E13–Invalidvalue(thenumberisoutofrange/toolarge)
E14–Notvalidforthisconguration
E17–Systemtimedout
E22–Busy
E24–Privilegeviolation
E26–Maximumnumberofconnectionshasbeenexceeded
E27–Invalideventnumber
E28–Badlenameorlenotfound
E30–Hardwarefailure(followedbycolonanddescriptornumber)(Thisisan
unsolicited response.)
E31–Attempttobreakportpass‑throughwhennotset
Error response references
The following superscripted numbers are used within the command descriptions
on the following pages to identify commands that may respond as shown:
14
=CommandsthatgiveanE14(notvalidforthisconguration)responseifthe
unit’scurrentcongurationdoesn’tsupportthatcommand.
22
= Commands that yield an E22 (busy) response.
24
=CommandsthatgiveanE24(privilegeviolation)responseifyouarenotlogged
in at the administrator level.
27
=CommandsthatmayyieldanE27(invalideventnumber)response.
28
=CommandsthatmaygiveanE28(lenotfound)response.
 previous next