Filter
Top Products
Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
© 2009 Extron Electronics. All rights reserved.
Determine which rooms will have IP Intercoms and HelpDesk PCs and where,
in each room, they will be located. Ensure there is a network connection for each
intercom and each HelpDesk PC.
For the IPI 100 Series models
Connect the IPI to the MLC 226 IP controller, using the included 12 inch (30.5 cm)
network cable (see page 2-2).
Cable the MLC 226 IP to other devices:
• Connect the LAN port to the local network, using a standard network cable with
an RJ-45 connector.
• If desired, cable the rear panel audio connector for local audio output (see
page 2-2).
• Cable other devices (control modules, SCP, and/or IR emitters) to the MLC
as needed (for more information, see the MLC 226 IP User’s Manual, which is
available on the Extron website (www.extron.com).
Install the IPI 100 unit and the MLC 226 IP into the wall box(es) or furniture (see
page C-2).
Ensure the HelpDesk PC(s) is connected to the network and power it on.
Configure the MLC(s) as described in the MLC 226 IP User’s Manual and the Global
Configurator Help File, which are available on the Extron website
(www.extron.com).
For the IPI 200 Series models
Connect the LAN port to the local network, using a standard network cable, with an
RJ-45 connector (see page 2-3).
Connect power, and, if required, contact relay and local audio output, using the rear
panel captive screw connectors (see page 2-3).
Mount each IPI 200 into furniture, an AAP wallplate, mounting bracket for 2-gang
wallplates, or device faceplate. The AAP versions must be secured by attaching a
clamp bracket to the back of the intercom after it has been inserted through the front
of the AAP plate (see page C-3).
Ensure the HelpDesk PC(s) is connected to the network and power it on.
For all models
Install the Extron IP Intercom HelpDesk software, which is on the disk that shipped
with the unit and is also available for download from the Extron website
(www.extron.com).
Use the IP Intercom HelpDesk software to configure all intercom units in the system
(see chapter 5). Full instructions can be found in the software’s Help File.
When the front panel button(s) light amber, the unit is correctly installed and
configured. If the button(s) light red the unit has not been correctly configured and you
should check the IPI 100 Series and IPI 200 Series User’s Manual or the software’s Help
File.
Quick Installation Checklist