Fluke DSP-2000 Network Card User Manual


 
Getting Started
Rotary Switch
2
2-19
Setup
Allows you to do the following:
Select a test standard and cable type.
Select an average cable temperature when temperature is required by the
selected test standard.
Set the test tool to test cable installed in conduit when a conduit setting is
required by the selected test standard.
Enable remote testing or automatic remote detection when you use a second
main unit or a smart remote as a remote unit.
Set the cable identification number to increment automatically each time you
save Autotest results.
Set the backlight timer to turn off the backlight after a specified period of
inactivity.
Set the power-down timer to switch the test tool to a low-power mode after a
specified period of inactivity.
Set the fault threshold for the impulse noise test.
Select interface parameters for the serial port.
Enable or disable the test tool’s beeper.
Set the date and time.
Select a format for the date and time.
Select a unit for length measurements.
Select a format for displaying decimal fractions.
Select a language for the display and printed reports.
Select a frequency for the power line noise filter.
Enable or disable the shield continuity test.
Modify test standards for custom cable configurations.
Select 100 MHz or 155 MHz as the maximum frequency for NEXT, ACR, and
attenuation tests.