Filter
Top Products
6-16 MPC860T (Rev. D) Fast Ethernet Controller Supplement MOTOROLA
PRELIMINARYÑSUBJECT TO CHANGE WITHOUT NOTICE
6.2.16 FIFO Receive Start Register (R_FSTART)
The R_FSTART register, shown in Figure 6-16, is programmed by the user to indicate the
starting address of the receive FIFO. R_FSTART marks the boundary between the transmit
and receive FIFOs. The transmit FIFO uses addresses from X_FSTART to R_FSTART - 4.
The receive FIFO uses addresses from R_FSTART to R_BOUND, inclusive.
Hardware initializes R_FSTART with a value that is microcode-dependent after
ECNTRL[ETHER_EN] is set. R_FSTART only needs to be written to change the default
value.
Table 6-18 describes R
Ñ
FSTART Þelds.
6.2.17 Transmit Watermark Register (X_WMRK
The X_WMRK register is used to control the amount of data required in the transmit FIFO
before transmission of a frame can begin. This allows the user to minimize transmit latency
(X_WMRK = 0x) or allow larger bus access latency (X_WMRK = 11) due to contention
22Ð29 R_BOUND Read-only. Highest valid FIFO RAM address.
30Ð31 Ñ Reserved. Should be written to zero by the host processor.
Bits 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Field Ñ
Reset 0000_0000_0000_0000
R/W Read/write
Addr 0xED0
Bits 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
Field Ñ 1 R_FSTART Ñ
Reset 0000_0000_0000_0000
R/W Read/write
Addr 0xEDC
Figure 6-16. R_FSTART Register
Table 6-18. R_FSTART Field Descriptions
Bits Name Description
0Ð21 Ñ Reserved. Note all bits read back as 0 except for 21 which returns a 1.
22Ð29 R_FSTART Address of Þrst receive FIFO location. Acts as a delimiter between receive and transmit FIFOs.
30Ð31 Ñ Reserved. Should be written to zero by the host processor.
Table 6-17. R_BOUND Field Descriptions
Bits Name Description
Fr
eescale S
emiconduct
or
, I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...