Filter
Top Products
CONNECT2AIR™ WLAN AP-600RP-USB Page 20 / 62
6.5 Two AP-600RP-USB in repetition mode (WDS)
( 2 ) AP-600RP-USB Floor 1 ( 3 ) AP-600RP-USB Floor 2 ( 4 ) Notebook
WAN: PPP over Ethernet
LAN: static IP: 192.168.1.254
subnet Mask: 255.255.255.0
DHCP on: 192.168.1.10 - 90
GW: 192.168.1.254
DNS: auto
SSID: CONNECT2AIR
Channel: 11 (same as AP 2)
WDS: MAC addr. of AP-600RP-USB 2
listed in the table
WAN: no ISP
LAN: static IP: 192.168.1.253
subnet Mask: 255.255.255.0
GW: 192.168.1.254
DHCP disabled
SSID: CONNECT2AIR
Channel: 11 (same as AP 1)
WDS: MAC addr. of AP-600RP-USB 1
listed in the table
TCP/IP: get IP and DNS
addresses
automatically
SSID: CONNECT2AIR
Data Rate: auto
The ADSL Modem (1) does not have to be configured.
Connecting the devices to the AP-600RP-USB:
AP-600RP-USB Floor 1
AP-600RP-USB Floor 2
Connect the ADSL Modem to the WAN port of the AP1, otherwise the PPPoE session
cannot be established and therefore the Internet service cannot be opened. Additional
networking devices like network printers, servers or scanners can be plugged into one of
the free LAN ports of the AP1 or AP2 and will be integrated in the IP segment of
192.168.1.X.
Installation Note
In order to have more range, up to 6 AccessPoints can be linked together. This case de-
scribes the configuration of linking two APs together where AP1 is the managing one,
which initiates the PPPoE session and acts as DHCP server. The SSID and the radio
channel must be equal for all APs linked, otherwise no connection can be established. Fur-
thermore, every AP has to know its counterpart, therefore a MAC address table is provided
to enter the appropriate AccessPoint.
5
5
5
1
X
3
4
4
5
4
1
2