Filter
Top Products
Chapter 5 Troubleshooting
IP-9610
48
No.
Class Status
Description Recommended action
9.
Is the power to the communication
destination device turned on?
Verify the power supply and operation of
the communication destination device.
10.
The LINK/ACT
LED for the
LAN port is not
turned on.
Are the LINK LEDs on this device
and the hub turned on?
If the LINK LEDs are not ON, the LAN
cable is not connected. Connect the LAN
cable correctly.
11.
Is the IP address specified from the
Web browser correct?
Specify a correct IP address from the Web
browser on the control terminal.
12.
Are the network settings (IP
address, subnet mask, etc.) on the
control terminal PC correct?
Make correct settings by referring to the PC
user's guide and OS handbook. If this
device is started with the default settings
made before shipment from the factory, see
"Section 3.4, " Special Use of CANCEL
Key," for the network settings for the
control terminal PC.
13.
Line
Device setting
through a LAN
is disabled.
Is a reply received in response to a
PING command issued to the IP
address of the device?
If a reply is not received, turn on the power
to the device while holding down the
Cancel key to start the system with the
default IP address (10.0.0.1) set before
shipment from the factory. Confirm the IP
address. If the problem persists, check the
status on the LAN. For information on
this startup procedure, see Section 3.4,
"Special Use of CANCEL Key."