Fujitsu M3099GH Scanner User Manual


 
3-17
Button Specification(M3099GX/GH)
This section describes the button specifications.
Manual
button
This button is used to select manual feed mode. Pressing this button switches the setting between Manual
mode and ADF mode.
When this button is pressed, the scanner enters manual feed mode and the hopper goes up. If the button
is pressed again, the scanner exits manual feed mode and the hopper goes down.
Start
/
Stop
button
These buttons are usedd in Off-line mode. When
Start
button is pressed in Off-line mode, the scanner
starts document feeding. When
Stop
button is pressed in Off-line mode, the scanner stops document
feeding.
Stop
button is also used in On-line mode to cancel the temporary error condition.
Mode 1
button
This button is used to transit to SETUP mode when the power is on. When
Mode 1
button is pressed and
power is turned on, the scanner enters SETUP mode.
Mode 2
button
This button is used to transit to maintenance mode when the power is on. When
Mode 2
button is pressed
and power switch is turned on, the scanner enters maintenance mode. Maintenance mode is used for
maintenance/diagnostic purpose. See M3099EX/GX/EH/GH IMAGE SCANNER CE MANUAL.
07-Chap. (3) 98.2.20, 10:52 AM17