Fujitsu M3099GH Scanner User Manual


 
7-4
8 Press
Mode 1
and
Mode 2
at the same
time to display Screen 4. The settings
are stored in EEPROM.
When you close, press
Stop
.
Mode Details
ON/OFF “OFF” is default setting.
1 “1” is default setting.
This mode is used when a batch of documents whose length are same is scanned.
When a document with tears and wrinkles is scanned, the scanner may also fail to
detect the double-feed.
2 This mode is used when a batch of documents whose length and thickness are same is
scanned.
However, when a thin document is scanned, the scanner may fail to detect the double-
feed rarely.
\In this case, please test scanning of a thin document in advance.
No
IPC-2 SET
<Screen 8>
<Screen 9>
1 AT Screen 2, press
Mode 1
twice to
go to the IPC-2 SET screen. <Screen 8>
2 Press
Mode 2
to see Screen 9 or 10.
If “No” is displayed, IPC-2 pre-set mode
is not used.
If pettrn number (“1”-“5”) is displayed,
IPC-2 pre-set mode is used.
“No” or number status flips each time you
press
Mode 1
.
(The default setting is “No”.)
Setting IPC-2 pre-set mode
When you set the using of IPC-2 pre-set mode, you must set as follows:
<
>
<
>
SE
T
U P M O D
E
IPC-2 SET
15-Chap. (7) 98.2.20, 10:56 AM4