Fujitsu PCI GigabitEthernet 3.0 Network Card User Manual


 
3.3 Operation Mode Setup
Auto-Negotiation off) from Auto-Negotiation mode.
Setup to FCode is effective between OBP (Open Boot Prom).
1) The mode which can be set up on PW008GE4/PW0G8GE1/SE0X7GD2X (1000BASE-SX) is
as follows.
Execute the following command to set Full Duplex communication, 1000Mbps.
example) ok transfer-speed=1000
2) The mode which can be set up on
PW008GE5/PW0G8GE2/SE0X7GD1X/PW008QG1/SE0X7GQ1X and PRIMEPOWER250/450
secondary LAN port is as follows.
Execute the following command to set Full Duplex communication, 100Mbps.
example) ok transfer-speed=100
Execute the following command to set Half Duplex communication, 100Mbps.
example) ok transfer-speed=100
example) ok half-duplex
Execute the following command to set Full Duplex communication, 10bps.
example) ok transfer-speed=10
Execute the following command to set Half Duplex communication, 10Mbps.
example) ok transfer-speed=10
example) ok half-duplex
● Display the current settings.
example) ok .properties
37