Gateway E-9425R Server User Manual


 
www.gateway.com
55
6 Remove the heat sinks and processors by following the instructions in “Replacing or adding
a processor” on page 43.
7 Disconnect all cables from the system board, noting their locations and orientation. (You
will reconnect the cables after you install the new board.)
8 Loosen the two thumbscrews (1) that secure the system board to the server.
9 Slide the system board toward the back of the server until it is free of the eight retaining
standoffs (2), then lift the board from the chassis.
10 Place the old system board in a static-free bag for storage.
11 Insert the new system board into the chassis, aligned with the eight retaining standoffs,
then slide the board toward the front of the case so the board is held by the standoffs.
12 Tighten the two system board thumbscrews you loosened in Step 8.
13 Connect the cables you removed in Step 7
14 Install the memory by following the instructions in “Installing memory” on page 36.
15 Install the processor and heatsink by following the instructions in “Replacing or adding a
processor” on page 43.
2
2
2
2
2
1
2
2