Filter
Top Products
HP Color Copier 210/210LX User’s Guide
1-151-15
1-151-15
1-15
8 T8 T
8 T8 T
8 T
urn the Copier Onurn the Copier On
urn the Copier Onurn the Copier On
urn the Copier On
The switch is located on the right side, lower-front corner of the copier. When
the switch is in the off position, the machine is in a “standby” condition. This
means that although it is not functional, power is still applied.
When the machine is turned on, it must complete an initialization sequence
before it will be ready to make copies. If you open the lid during the initial-
ization, the message Close lid will appear. You will not be able to use the
copier until you close the lid and allow the initialization to finish.
If a new print cartridge was installed while the copier was off, the copier
automatically aligns the print cartridges . This procedure takes about 60 seconds.
The alignment procedure prints a page, so paper needs to
be loaded in the copier when it is turned on. Discard the page.
■ If the message Unlock scanner. Move green scanner lock on left side under lid
to unlocked position, and turn power off then on. appears, return to Step 3 to
for instructions on unlocking the scanner.
■ If the message Remove and check xxxx cartridge. appears (where xxxx is a
color), verify that the print cartridges are snapped all the way back in
their stalls. Return to Step 4 for instructions.
Push down the left side of the switch
to turn on the HP Color Copier.