HP (Hewlett-Packard) 210/210LX Copier User Manual


 
HP Color Copier 210/210LX User’s Guide
6-36-3
6-36-3
6-3
Front-Panel MessagesFront-Panel Messages
Front-Panel MessagesFront-Panel Messages
Front-Panel Messages
Message Possible cause Solution
Paper Jam. Paper has jammed in copier or automatic Refer to “Clearing Jammed Paper” later
document feeder. in this chapter.
If only one or two sheets of paper are in the Remove the paper jam and install more
paper tray, the copier might not pick the paper in the paper tray.
paper properly, causing a paper jam in the
copier.
HP Premium Transparency Film was loaded Remove the paper jam and load HP
with the wrong end going in first, causing a Premium Transparency Film in the paper
paper jam. The jam is caused by the sensor tray with the white strip going in first and
not finding the paper strip; therefore it finds on top.
no paper. You can also get an Out of Paper
message.
Out of paper Paper tray is out of paper or the paper is not Load paper into paper tray.
fully inserted into the tray.
Remove and check A print cartridge is either incorrectly Reseat or replace the print cartridge into
[black or color] cartridge installed, the wrong type, or defective. correct cartridge stall. Make sure the tape
has been removed from the print cartridge
nozzles. Be sure cartridges are inserted
fully forward and snapped into place.
ADF Paper Jam. Paper is jammed in the automatic Refer to “Clearing Jammed Paper in the
document feeder. Automatic Document Feeder” later in this
chapter.
Unlock scanner. The scanner was not unlocked when the Turn off the copier. Press the blue button
copier was set up. on the right side of the copier to open the
machine. On the left side near the hinge is
a green scanner lock. Move it to the open
position.
Refer to “Unlock the Scanner” in Chapter
1 for directions with pictures.
[Black or color] Ink Low. Print cartridge is running out of ink. Replace print cartridge. (You might be
able to copy some more pages. Press
Select/Resume to continue.)
Lid Open. After pressing the blue button to open the Close lid.
machine, the lid was not closed securely.